About this map

← Back to the map

Colorado Rivers & Flows shows how much water is running in Colorado's rivers and creeks right now, and how that compares with normal for each stretch of river.

Not for safety decisions. Readings come from automated gauges and can be late, missing or wrong, and many flows on this map are estimates worked out from other gauges. Before you float, fish or wade, check the official gauge (linked in each popup) and conditions on the ground.

Reading the map

Each river is drawn as a line, split into sections at its stream gauges.

Median colours

ColourFlow compared with the median
Dark brownUnder 50%: much lower than usual
Tan50–80%: lower than usual
Teal80–125%: about normal
Blue125–200%: higher than usual
NavyOver 200%: much higher than usual
Light greyNo reading, or no reliable median to compare with (see doubtful comparisons)

The median behind each colour is either long-term or from just the past year (see Percent of median), so treat very high or very low percents with care. The colours run from brown (dry) to navy (wet) and are chosen to stay distinguishable for people with the common kinds of colour blindness.

Where the data comes from

WhatSource
Flows at about 250 gaugesU.S. Geological Survey (USGS) National Water Information System
Flows at about 210 gaugesColorado Division of Water Resources (DWR) telemetry stations
Reservoir storage and diversion records (used in a few estimates)Colorado DWR
Long-term mediansUSGS gauges: USGS daily statistics, over each gauge's whole approved record. DWR gauges: worked out from up to 20 years of DWR daily flows (since 2006).
River linesUSGS National Hydrography Dataset (NHD)
Background mapUSGS The National Map ("USGS Topo")

Each popup names its gauge and links to that gauge's own page at USGS or DWR. Gauges in neighbouring states are included where a Colorado river runs through them (for example the San Juan in New Mexico and the Little Snake in Wyoming).

How fresh the readings are

Rivers split into sections

A river with several gauges is split into sections, one per gauge. A section runs from its gauge (or from where a tributary joins) down to the next gauge, and shows that gauge's flow. The popup says which section it is, for example "Section 6 of 10: At Fort Collins → Above Boxelder Creek". In the sidebar, click a river to list its sections.

Calculated (estimated) flows

Many stretches have no gauge of their own, for example below where a tributary joins. For these the map works out an estimate from nearby gauges, marked (calculated) in its name, with a hollow, dashed gauge dot. The popup shows the formula, for example:

Below North Fork at Drake = Below Lake Estes (Big Thompson) + At Drake (North Fork Big Thompson)

Calculated flows are shown with ≈, for example "≈ 38 cfs", as a reminder that they're estimates.

Allowing for travel time

Water takes time to move down a river, so a calculation doesn't simply use each gauge's latest reading. The map works out how far each gauge is from the calculated point along the river (and down any tributary), assumes the water moves at about 3 miles an hour, and uses each gauge's reading from when this water passed it. For example, the Little South Fork's water takes a few hours to reach the Poudre's canyon-mouth gauge, so the Poudre above that confluence is worked out from the canyon-mouth reading hours later. A calculated flow therefore describes one moment at that point, shown as "Estimate for" in its popup; when the inputs include a gauge far downstream, that moment can be several hours ago. An estimate more than 3 hours old says how old it is (for example "≈ 16 cfs · 18 h ago") and its line is drawn paler on the map. Each popup's How it's worked out shows the gauges it uses. Real travel times vary with the amount of water and the channel, so this is an approximation.

Treat calculated flows as rough. They don't know about every diversion, ditch, seepage or travel time, so an estimate can sit above or below the real flow, and sometimes above the measured gauge just downstream.

Fallback readings

A few gauges have a fallback: when the gauge hasn't reported for 24 hours (often because it's off for winter), the map shows a nearby related gauge instead. These are marked with * in the sidebar, and the popup says which gauge is being used.

Percent of median

The median is the "typical" flow: half the time the river runs higher, half the time lower. The popup shows today's flow as a percent of it, for example "119% of median: 20 cfs long-term median". Which median is used depends on the gauge:

GaugeMedianWhat it means
USGSLong-term medianThe median for this day of the year, over every year on record (often 40–100 years). The best comparison: it allows for the season.
DWRLong-term median (usually)The median for this day of the year over up to 20 years of DWR records, so it allows for the season too. A gauge with fewer than 5 years of records for the date (a newer gauge, or one that's off in winter) uses its past-year median instead.
CalculatedPast-year medianWorked out day by day over the past year with the same formula. A past-year median doesn't allow for the season (a winter flow is compared with a year that includes spring runoff) and one dry or wet year can skew it.

Seasonal gauges that are off in winter only count the days they ran, so a past-year median leans toward summer flows.

Doubtful comparisons (?)

Some percents aren't meaningful, so the map marks them with a ? (for example "2,276% of median?"), explains why in the popup, colours the section light grey, and leaves it out of the percent filter. A comparison is marked doubtful when:

Low → peak

Percent of median says how full a river is for the date. Low → peak says how full it is for the year: where today's flow sits between the gauge's typical low and its typical runoff peak, for example "Low → peak: 2%: typical low 7.4 cfs (Nov 15), runoff peak 864 cfs (Jun 7)".

Rising and falling

Each section's latest reading is compared with its last saved reading 2–12 hours earlier.

The small chart in each popup shows the readings saved over the last 7 days, with the median as a dashed line.

Symbols and labels

You seeMeaning
cfsCubic feet per second, the usual unit for river flow (see Glossary)
— cfsNo reading available
≈ 38 cfsA calculated flow: an estimate from other gauges
245%? / 2,276% of median?A doubtful comparison with the median; the popup says why
0.8–534 cfsOn a river's sidebar row: the lowest and highest section flows
12–359%On a river's sidebar row: the lowest and highest percent of median
34×34 times the median (3,400%); used from 1,000% up
▲ ▼ ▬Rising, falling, steady
*Showing a fallback gauge's reading
staleReading more than 24 hours old
(calculated)An estimate from other gauges, not a measurement
Solid white dot / hollow dashed dotA real gauge / a calculated point (dots appear when zoomed in)
★ / ☆A favourite river / add to favourites
↗ ShareShare or copy a link to that river or section
24 cfsFlow label on each section while one river is shown on its own

Using the map

Finding a river

Filters

Click Filters above the river list to open them; it says how many are on.

Saving and sharing

On a phone

Visitor counts

The site keeps simple counts on its own server: page views and visitors each day, phone or computer, which site you came from, which shared links are opened and which river sections' details are looked at. It uses no cookies and no outside analytics service, and doesn't keep IP addresses: visitors are counted with a code that changes every day, so no one can be followed from one day to the next.

Glossary

cfs (cubic feet per second)
How much water passes a point each second. One cfs is about 7.5 gallons a second. A small creek might run 1–20 cfs, the Poudre in Fort Collins 20–2,000 cfs, and the Colorado at the Utah line thousands.
Gauge
An automated station that measures a river's water level and converts it to flow.
Basin
All the rivers that drain into a main river (for example every stream that ends up in the Arkansas).
Confluence
Where two rivers meet.
Diversion
Water taken out of a river by a ditch, pipeline or tunnel, usually for irrigation or cities.
Median
The middle value: the flow is above it half the time and below it half the time.
Provisional data
Recent gauge readings that haven't yet been checked; agencies may revise them.

Privacy

This site uses no cookies, accounts, ads or tracking. Your settings (favourites, colour and line-width choices, folded panels) are saved only in your own browser and never sent anywhere; clearing your browser's site data removes them. Map tiles are loaded from the map provider, which sees your IP address like any web request.

← Back to the map